Switch service tip
Switch Infinity utilizes a patented translating pivot that switches direction as the bike moves through its travel. This provides a tailored anti-squat curve while delivering a fine-tuned leverage ratio. Yeti recommend using their grease gun to add new grease between every 25-100hrs based on conditions. We also recommend checking the bearings and grub screws every 300-400hrs. To check the grub screws, please follow instructions below. You need to remove the non drive side bearing first. Behind this are 4 grub screws. You will need a 2mm allan key to back them right off. Then tighten back up until snug. If you use 12pm as a reference, tighten them to 1pm. And best to do them in this order : Top left - Bottom right...